30mm Low Sus-Tac AWE Scope Rings With 20 MOA inserts

The 30mm Low Sus-Tac AWE Scope Rings With 20 MOA inserts provide an adjustable mounting system for rifle scopes with a 30mm main tube. In addition, the system combines interchangeable elevation bushes with windage adjustment to help align the scope with your rifle.

30mm Low Sus-Tac AWE Scope Rings With 20 MOA inserts

In contrast to fixed-angle rings, the SUS-TAC AWE system lets you change the elevation offset by swapping the MOA bushes. As a result, you can adapt the mounting system to your required elevation setting without replacing the complete mounts.

For example, the specified bush combinations allow elevation offsets of 0, −10, −20, −30 or −40 MOA. However, the bush positions must match the manufacturer’s configuration guide. Therefore, consult the SUS-TAC AWE installation instructions before assembly.

In addition, adjustable windage clamps help correct lateral misalignment between the rifle action and Picatinny rail. In particular, the manufacturer specifies 120mm ring centres for the stated configurations. Consequently, check your rail dimensions and the recommended spacing before installation.

Additionally, the rings use carbon steel with a matt GunKote finish. However, low rings may not provide sufficient clearance for every scope. For this reason, check the objective bell, barrel clearance and required eye relief before fitting the mounts.

Because correct bush alignment is important, keep each bush’s upper and lower halves matched. Furthermore, never mix different MOA values within a single ring. Instead, check each bush pair and its orientation against the manufacturer’s instructions to avoid incorrect assembly.

First, set the cap screws to the initial 5 in-lb setting as directed in the installation guide. Then tighten the screws alternately, following the scope manufacturer’s torque limit. However, do not exceed the scope manufacturer’s recommended setting.

Next, start at 10 in-lb for the windage adjustment nuts and increase the torque in stages. Finally, follow the SUS-TAC instructions for the specified final windage nut setting of 50 in-lb.

Key Features and Specifications

• In addition, these rings fit rifle scopes with a 30mm main tube
• Also, they use the low-height SUS-TAC AWE mounting system
• The supplied inserts provide a 20 MOA bush configuration
• Furthermore, interchangeable bushes support the specified elevation offsets of 0, −10, −20, −30 or −40 MOA
• Additionally, adjustable windage clamps help correct lateral alignment
• The mounts use carbon steel with a matt GunKote finish
• Moreover, the rings fit a Picatinny rail
• For correct setup, use the recommended 120mm ring centres
• First, tighten the scope cap screws to the initial 5 in-lb setting
• Finally, follow the manufacturer’s instructions for the scope cap screw limit and 50 in-lb final windage nut torque

In summary, these adjustable scope rings provide flexibility when setting scope elevation and alignment. In addition, you can change the bush configuration to suit your required offset. Additionally, for related mounting options, see the scope rings and bases range. Finally, confirm the bush combination and torque settings in the manufacturer’s instructions before installation.