Lynx 25mm Med Ring Set Brno 600 /CZ 550 – Steel

The Lynx 25mm Med Ring Set Brno 600 /CZ 550 – Steel provides steel scope rings for compatible Brno 600 and CZ 550 rifles. The medium-height design suits scopes with a matching nominal 25 mm tube diameter. However, you should confirm both the rifle’s receiver profile and the scope tube size before installation.

Lynx 25mm Med Ring Set Brno 600 /CZ 550 – Steel

These Lynx rings provide a mounting option for compatible Brno 600 and CZ 550 rifle receivers. Unlike a rail-mounted system, this type of set fits the matching receiver mounting profile directly. Therefore, check your rifle’s dovetail dimensions before choosing the rings, especially if a previous owner modified the receiver.

The rings use steel construction and a medium-height profile. As a result, they offer a middle ground between low and high rings when setting scope height. However, the correct height also depends on your scope’s objective bell, barrel contour, bolt handle and preferred cheek position. For example, a large objective lens may need more clearance than a compact hunting scope.

The product uses a nominal 25 mm scope-tube designation. Since one inch equals 25.4 mm, check the scope manufacturer’s stated tube diameter rather than relying on rounded measurements. In addition, do not confuse the scope tube diameter with the receiver’s dovetail width; these measurements describe different parts of the mounting system.

The listed medium-ring height is approximately 12.3 mm. This figure refers to the distance from the receiver top to the underside of the ring, where the scope tube rests. Nevertheless, confirm the measurement reference if you need precise clearance for your rifle and optic. Before tightening the rings, check that the scope clears the barrel and that the bolt operates freely.

During installation, position the scope at a comfortable eye relief and make sure the reticle sits level. Then tighten the fasteners according to the manufacturer’s instructions. Also, check that both rings sit evenly on the receiver and clamp the tube securely without damaging it.

For further product information, visit the official Lynx mounts and rings page. You can also compare alternative mounting options in our scope rings and bases range.

Key Features and Specifications

• Steel construction.
• Medium-height scope ring set.
• Intended for compatible Brno 600 and CZ 550 receivers.
• Nominal 25 mm scope-tube designation.
• Listed ring height of approximately 12.3 mm.
• Check receiver fit, scope diameter and clearance before installation.

Overall, these Lynx steel rings provide a medium-height mounting option for compatible Brno 600 and CZ 550 rifles. Therefore, confirm the receiver profile, tube diameter and required clearance before fitting the set.